Telephone Equipment and Service

Basic cabinet, I required with each system, can work with an expansion cabinet for a maximum of 17 card slots. Houses I or 2 power supply(s), DC/DC board, CPU and peripheral boards.

Mounts above the basic KSU and provides 10 additional card slots for peripheral boards (except T-1, DTIB-E, and ISDN).

Mounts to right of basic KSU or expanded KSU and provides 6 additional card slots for peripheral boards (exceptT-1 and ISDN).

Required to support background music/mLisic on hold (2 channels), 6 relays (miscellaneous), and 2 external page zones.

Optional unit to transfer up to 6 CO lines to 6 SIT telephones/ stations.

Provides 2 additional RS-232C ports using RJ-45 jacks used for SMDR or Caller ID reporting

Power supply requirements are based on boards used in the system. Digital station boards require morc power than other types of boards. See charts in manual for guidelines or use ConfiguratorTm Autoquote program.

Power supply requirements are based on boards used in the system. Digital station boards require morc power than other types of boards. See charts in manual for guidelines or use ConfiguratorTm Autoquote program.

Required when system exceeds 48 CO lines or 96 stations.

Optional board mounts in the DC/DC board to support backup batteries. Batteries not included.

Used whenever single line telephone boards are installed on system. Supplies ring and message waiting voltage.

Required for system, converts 24-volt DC power to regulated voltages (+5v, -5v, +12v). Also provides 48-volts for DID board.

Equipped for 8 DID CO lines.

Equipped for 8 loop start CO lines.

Equipped for 8 ground start CO lines.

Optional module provides 4 receivers, installs on loop start, ground start, or DID CO line board to supply additional DTMF receivers to the system.

Kit includes T-1 board, cables for T-1 circuit and CSU.

Optional module provides 4 receivers, installs on single line board and T-1 board to supply additional DTMF receivers to the system

(ETIB-12) Equipped for 12 electronic key station ports.

Supports direct T- I interface of up to 24 channels. A maximum of four T-I's per system.

Required when using T-1 board, to regulate clock signals.

(SLIB-12) Equipped for 12 single line telephone ports.

(DTIB-12) Equipped for 12 digital station ports. Supports the 9032-10 expansion board.

Optional board installed on single line board when message waiting lamps are required on single line telephones.

(DTIB-E) Equipped for 12 digital station ports. Mounts on the 9032-00 DTIB-12 board.

Provides connection between PC and anyTRLkD digital telephone.

MPB required with each system. Supports program module, one on-board RS-232 port and modem for remote programming. Optionally can support Serial Interface Unit for two additional RS-232 ports and Phase Lock Loop Unit.

Database programming software for the PC.

Interfaces 4 CO lines. Includes documentation and power supply.

Interfaces 8 CO lines. Includes documentation and power supply.

Connects Caller ID unit to KSU. One required for each Caller ID unit